Fuel Lines
The highlighted comment was created in this revision.
Creating a comparison table would be valuable here but should be backed up with sources. Anyone have any resources on price breakdowns of hard vs soft lines for example, or datasheets from suppliers outlining pressure capacity?
they dont seem to be 100% consistent across suppliers or diameter, but i'll try to note each in the table
I created a comparison table for the qualities of the line types. I spitballed the numbers here and it would be nice if someone took a look at them and backed them up or adjusted them.
the way we used to do these kinds of charts were to use the hard numbers and normalize to the largest so everything is <1 to keep the numbers comparable across chriteria, and so we didn't just give our favorite high numbers. not sure how we'd do manufacturability or reusability objectively though. might have to just be crowd consensus. I'll see if i can dig up an objective alternative/addition to the subjective characteristics.
